Danelectro Dan-Echo Manual do Utilizador descarregar pdf (Página 3)

Connect instrument cable to the IN jack. Battery power is

activated when cable is connected to IN jack. Connect

amplifier cable to the OUT jack. If using Danelectro AC

Adaptor, connect to DC 9-Volt jack.

LED light will be on when foot switch is activated.

Control Functions:

MIX: Use to select the mix of dry to echo/delay signal.

HI-LO: Use to set long (Hi) or short (Lo) echo/delay times.

SPEED: Use to select the length of echo/delay within the

HI or LO speed range selected.

REPEATS: Use to set the number of repeats.

HI CUT: Cuts the high frequency on the delayed signal.

Each successive repeat suffers further high

frequency cut. This simulates a vintage tape

echo.

Dan-Echo

DE-1 INSTRUCTIONS

•

BATTERY: Uses one S-006P 9-Volt Battery. Danelectro “Vintage Power Source”

batteries are recommended.

Battery Eliminator: Uses 9-Volt battery eliminator. Polarity: Center negative (–) adaptor

plug. 300mA maximum. Danelectro Zero Hum

™

DA-1 Adaptor is recommended.

SOLO DELAY

CONTROL SETTINGS

MIX

SPEED

LO-HI

REPEATS

HI-CUT

1 2 3 4 5 6 7 8 ... 17 18

Sem comentários

Danelectro Dan-Echo Manual do Utilizador Página 3